Q.71. Ranging is defined as
(a) measuring the distance from starting point
(b) establishing intermediate points on a chain line
(c) the distance between end points
(d) a point on a chain line
Answer : option B
Q.72. Compute the angle between the lines AB and AC, If their respective bearings are 52°30' and 328°45'.
(a) 276°15'
(b) 6°15'
(c) 111°15'
(d) 83°45'
Answer : option D
Q.73. The size of fillet weld is indicated by:
(a) Size of the plate (b) Side of the triangle of fillet
(c) Throat of the fillet
(d) Length of fillet weld
Answer : option B
Q.74. In limit state method of design, for bars in compression in values of bond stress shall be
(a) Decreased by 25%
(b) Increased by 20%
(c) Decreased by 20%
(d) Increased by 25%
Answer : option D
Q.75. The damp proof course (D.P.C) of uniform thickness in a building having walls of different widths is measured in
(a) m⁴
(b) m³
(c) m²
(d) m
Answer : option C
Q.76. Volume by Trapezoidal Formula Method determined by the formula
Answer : option D
Q.77. The value of the property at the end of its useful life (without being dismantled) is known as
(a) Salvage value
(b) Scrap value
(c) Book value
(d) Junk value
Answer : option A
Q.78. Tacking rivets in compression plates exposed to weather have a pitch not exceeding 200 mm or:
(a) 8 times the thickness of outside plate
(b) 16 times the thickness of outside plate
(c) 24 times the thickness of outside plate
(d) 32 times the thickness of outside plate
Answer : option D
Q.79. Depth of the section of an upper column is much smaller than the lower column:
(a) bearing plates are provided with column splice
(b) filler and bearing plates are provided with column splice
(c) filler plates are provided with column splice
(d) neither filler nor bearing plates are provided with column splice
Answer : option B
Q.80. Web crippling in beams generally occurs at the points where:
(a) concentrated loads act
(b) bending moment is maximum
(c) shear force is maximum
(d) deflection is maximum
Answer : option A
No comments:
Post a Comment